Coban - GPS306

Working Based on existing GSM/GPRS network (850/900/1800/1900Mhz) and GPS satellites, this product can locate and monitor any remote targets by SMS or internet.


  • Change Password
  • Authorization
  • Single Locating
  • Auto track continuously
  • Automatic update positions of vehicle turns
  • GPS drift suppression
  • Absolute street address by SMS
  • Location based service (LBS)
  • Voice Monitor -Data logging
  • Data Load
  • Forward the third parties’ message
  • Charges Inquiry
  • mainteanance remind alert
  • Low battery alarm
  • External Power off alarm
  • GPS blind Spot alert
  • Geo-fence
  • Multi-area management
  • Movement alarm
  • Over speed alarm
  • Alarm without GSM network service
  • Check the Vehicle State
  • Reset Hardware
  • Sleep Mode
  • Sleep by time
  • Sleep by shock sensor
  • No sleep mode
  • Set up Terminal (local) Time
  • TCP / UDP Switch
  • GPRS setting
  • Setting up APN
  • GPRS User ID and password Setup
  • IP and port setup
  • Less GPRS traffic
  • Modes Switch between “SMS” and “GPRS”
  • Set up monitor center number
This information only is for informational purposes only, Factory IL GPS does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up GPS306


To set CAbvrZ6 0M jRT you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 123456 which is the initial setting from the device

  1. Factory reset
  2. Set the time zone UTC-0
    a1lT huypMjD3TI M
  3. Set up our operator APN
    UopCLVORT 9wKuWrj
  4. Set the username and password of APN operator
    5HOq2vkQ TqdMlkpm LMwaXcIL
  5. Establish the server where we will connect
    vg75FwyUg8Ahz EFP6W2yb34oYV 7IH7
  6. Switch to GPRS mode to begin transmission UDP

To check settings 51CBNDb1788

To enable the status of the fuel sensor or improve the transmission of the status of the digital sensors c8DPAJRtj1y9Ch wT