Loading...

Coban - GPS303

Working Based on existing GSM/GPRS network (850/900/1800/1900Mhz) and GPS satellites, this product can locate and monitor any remote targets by SMS or internet.

Function:

  • Change Password
  • Authorization
  • Single Locating
  • Auto track continuously
  • Automatic update positions of vehicle turns
  • GPS drift suppression
  • Absolute street address by SMS
  • Location based service (LBS)
  • Voice Monitor -Data logging
  • Data Load
  • Forward the third parties’ message
  • Charges Inquiry
  • Alarm Function
  • Low battery alarm
  • External Power off alarm (Suitable for B, C and D model)
  • GPS blind Spot alert
  • SOS
  • Geo-fence
  • Multi-area management
  • Movement alarm
  • Over speed alarm
  • ACC working alarm (Option, for model B, C, D)
  • Fuel alarm (Option, for model C, D)
  • Cut off the Oil and Power System (Option, for model C, D)
  • Arm
  • Silent Mode
  • DISARM
  • Door alarm (Option for model C and D)
  • ACC alarm (Optional for model B,C,D )
  • Shock Sensor alarm
  • Alarm without GSM network service
  • Check the Vehicle State
  • Reset Hardware
  • Sleep Mode
  • Sleep by time
  • Sleep by shock sensor
  • No sleep mode
  • Set up Terminal (local) Time
  • TCP / UDP Switch
  • Configure parameters by USB
  • GPRS setting
  • Setting up APN
  • GPRS User ID and password Setup
  • IP and port setup
  • Less GPRS traffic
  • Modes Switch between “SMS” and “GPRS”
  • Set up monitor center number
This information only is for informational purposes only, Factory IL GPS does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up GPS303

Country
Operator
APN
User
Password

To set ueKSv71 jm xnN you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 123456 which is the initial setting from the device

  1. Factory reset
    hok5OEHb9jT
  2. Set the time zone UTC-0
    pp05 DPp2EhGZxK X
  3. Set up our operator APN
    WNZ0W1C2M rwtEe1q
  4. Set the username and password of APN operator
    XS2cuYOR iWKLLP9J 42gfKxNb
  5. Establish the server where we will connect
    sSm93l3aZerqm IvbqZsCNDcr5o 6AW1
  6. Switch to GPRS mode to begin transmission UDP
    QflYN1gUWXRy3L
    or
    G33wlP8XMV

To check settings i4mN1KS4G6y

To enable the status of the fuel sensor or improve the transmission of the status of the digital sensors jEaxFiTNTrRGnI jV